NCR 7169 - SNMP Setting

Configuration Network 7-146
SNMP Setting
This section discusses configuration parameters and default values for the SNMP
setting.
SNMPcommunity setting
Items
Default
value
Detail
Read Only public Displays the SNMP community read-only name. The
community name has a maximum length of 16 characters.
Read/Write Specifies the SNMP community read-write name.
The community name has a maximum length of 16
characters.
SNMP IP Trap1 setting
Items
Default
value
Detail
TRAP Disable Specifies the SNMP TRAP settings.
• Enable
• Disable
Address
0.0.0.0
Specifies the host address that receives SNMP TRAP.
Community
Name
Specifies the SNMP TRAP community name.
The community name has a maximum length of 16
characters.