Arabic Font Support F-166
Proportional font conversion handling of Arabic
Limitations
Because of the features of Arabic font, there are several limitations in terms of the
character attributes. For more information on the command description, refer to the
NCR 7169 Multifunction Printer Programmer's Guide (BCC5-0000-5352). Please see the
command description of Print Characteristic Commands in detail.
Invalid command list
The following table contains a list of commands that are not available if a new Arabic
character is used.
Command Command name Remarks
ESC DC2 Select 90 degree counterclockwise rotated print
ESC SYSN Select pitch (Column width)
ESC SP Set character right-side spacing
ESC ! Select print modes Bit0, Bit3 Invalid
ESC % Select or Cancel user-defined character set
ESC & 3 Define user-defined characters
ESC : Copy character set from ROM to RAM
ESC ? Cancel user-defined characters
ESC E Select or Cancel emphasized mode
ESC G Select double strike
To Next Page
Loading...