NCR 7169 - Ethernet Configuration Setting Page

Configuration Network 7-140
Ethernet Configuration setting page
Users can modify the ethernet configuration on the Ethernet Configuration setting page.
To change the ethernet configuration, follow these steps:
1. To change the configuration values, do one of the following:
• Enter a value in the corresponding field.
• Select an option from the drop-down list.
2.
Select SAVECONFIGURATION to save the new ethernet configuration in the printer
ROM.
If all values are valid and the saving process is successful, the Save Configuration
Message is then displayed. If any value is invalid, the new ethernet configuration is
not saved and an error message is then displayed. To check and retry changing the
values, select Top Page.
Note: To set the values to factory default, select FACTORYDEFAULT, and then
select SAVECONFIGURATION.