NCR 7169 - Ordering forms

1-60 NCR 7169 Multifunction Printer
Note: Take note of the following:
• Printer reliability and performance are directly related to the quality of supplies
used by the customer. The published reliability information for printer performance
is established using supplies that meet NCR specifications.
• Thermal paper with watermarks, coupons, or advertisements printed on its front or
back are not covered by NCR specifications. Some inks and printing processes work
acceptably, but others do not.
• Printer problems that are caused by supplies that do not meet NCR specifications
may result in expensive resolutions.
The following table provides information on other thermal papers tested with the
NCR7169 printer.
Paper
Manufacturer
MediaModel Notes
Koehler Blue4est
®
For more information, refer to
https://www.koehlerpaper.com/en/products/Thermal-
paper/Blue4est-thermal-paper.php
Ordering forms
The 7169 Printer prints on single-part or multiple-part forms in the slip station (up to
five-part forms). Forms and slips must meet the following requirements:
• Front insertion (minimum):
51 mm (2.0 inches) wide
70 mm (2.75 inches) long
• Side insertion (minimum):
203 mm (8.0 inches) wide
51 mm (2.0 inches) long
• Single-ply forms should be on paper that is greater than 15 pounds.
• Multiple-part forms (up to five parts) should be no thicker than 0.406 mm
(0.016inches).
• If multi-part forms are used, the cardstock must be the last ply of the form.
Note: To order forms, contact your sales representative.