Service Level Troubleshooting 3-96
Power Supply
This function allows users to set the maximum power for the printer to available modes.
• To select an option, press the Paper Feed button.
Set Standby mode
Enable or disable the Standby Mode using the configuration menu. If the standby mode
is enabled, the printer shifts to the standby mode in order to save power consumption in
when the printer is in idle mode.
The printer goes to standby mode if no transaction data is received after the following
conditions:
• 60 seconds after power on
• 1 second after one transaction
The printer exits from standby mode to normal mode in the following criteria:
• Printer receives any data
• Feed key is pressed
• Slip cover is opened or closed
• Receipt cover is opened or closed
Note: Opening or closing the flip cover does not affect the standby mode.
If this function is disabled, the printer does not shift to standby mode. When going back
from the standby mode, the response of the printer will be slightly delayed compared to
the normal mode response.
Caution: Be extremely careful in changing any of the printer settings. This is to avoid
inadvertently changing other settings that might affect the performance of the printer.
To Next Page
Loading...