NCR 7169 - Software or Hardware Configuration

NCR 7169 Multifunction Printer 1-17
Software or hardware configuration
To configure the software or hardware, follow these steps:
Note: Before configuring the printer, make sure that the printer is loaded with a paper
roll.
1. To know the current settings, print the diagnostics form.
a. Turn on the printer.
b. Open the receipt cover.
c. While pressing down the paper feed button, close the receipt cover. The printer
beeps and prints the diagnostics form.
2. Disconnect the power cable from the rear of the printer.
3. While pressing down the paper feed button, reconnect the power cable. The printer
beeps and prints the Main Menu.
4. Press the paper feed button according to the number of clicks presented in the main
menu, and then hold the button down for at least one second to validate.
The following is an example of configuring the printer for Emulation.
This option is to set Sync Mode, LPI, Carriage, Asian Mode, Code Page, Special Font,
Compress Pitch Font, 48 Character Mode, PDF417 Max Columns, Auto Reset mode,
Compatible Top Margin.
To enter into emulation mode, press the Paper Feed button twice as short click and do
long press until a beep sound is generated.