2-69 Troubleshooting Problems
MICR Check Reader Not Reading Properly
Cause What to Do Where to Go
Magnetic Ink Character
Recognition (MICR) check reader
does not read or misreads
checks
• Open the slip cover.
• Clean the MICR read
head with cotton swabs
and isopropyl alcohol.
(None)
Contact a service
representative if the above
steps do not resolve the
problem.
Refer to Contacting
a Service
Representative on
page75.
Stuck Cutter Blade
If a cutter blade is stuck in a fully extended position, do the following steps to fix it:
1. Open the front cover.
a. Unlatch the receipt front cover by pulling on the holes located on both sides of
the front cover.
To Next Page
Loading...