NCR 7169 Multifunction Printer 1-15
Checking for USB Support on the Host Computer
USB interface communications is required and the host computer must be equipped and
set up properly. With the required hardware in place, the Windows POSReady 2009
operating system natively supports plug–and–play USB with a built–in driver.
Note: You need an Internet access to download the USB drivers from the NCR Web
site: http://www5.ncr.com/support/support_drivers_patches.asp.
Host configuration
Verify that the proper hardware has been installed in the host PC.
The following steps are applicable to systems running on a Windows POSReady 7, a
Windows 8, or a Windows 10 operating system:
1. Open the Control Panel.
2.
Select Device Manager.
3. In the Device Manager window, scroll down the list of installed hardware devices
until you find an entry for Universal serial bus controller.
If this entry exists, your host computer is set up for USB operation. If this entry does not
exist, consult your computer documentation to see if USB must be enabled in the BIOS
setup.
To Next Page
Loading...