1-8 NCR 7169 Multifunction Printer
Repacking the printer
To repack the printer, follow these steps:
1. Place a receipt paper between the receipt cover and the print head for protection.
2. Remove the ribbon cassette, move the carriage to the corner, and place the
cardboard restraint in the slip carriage area.
3. Place the cardboard support on the slip table.
4. Place the printer in the plastic bag and foam pack.
5. Place the packed printer in the box, and then secure the box with packing tape.
Note: If you are sending the printer to NCR for repair, call your NCR authorized
service representative for instructions on where to send the printer. Be prepared to
answer questions concerning shipping and billing.
Choosing a Location
The 7169 Multifunction Printer takes up a relatively small counter space and may be set
on or near the host computer. Make sure there is enough room to open the receipt cover
to change the paper, or to open the front cover to change the ribbon cassette. The
following illustration shows the actual dimensions of the printer, but leave several
inches around the printer for connecting and accessing the cables.
Note: The Magnetic Ink Character Recognition (MICR) check reader feature is designed
to operate under a normal operating environment with a host computer. However,
additional devices, such as CRT monitors, or large metal surfaces that are near the
printer, can affect the printer's magnetic field and cause intermittent reading errors
when the MICR check reader is in operation. Relocating these devices may be required
to prevent this interference.
To Next Page
Loading...