NCR 7169 - Validating and Verifying Checks

NCR 7169 Multifunction Printer 1-55
Validating and Verifying Checks
If the MICR check reader feature is present, checks are verified and then validated.
1. Position the check on the slip table.
a. Insert the check from the front and place it on the slip table face down, with the
MICR characters to the right, as shown in the following illustration.
b. Slide the check to the right until it aligns with the guide or wall.
c. Slide the check toward the back until it touches the form stopper or align it with
any preset mark made on the slip table.
Note: When the check is properly inserted, the green LED on the slip table turns
on. That means that the check has covered the two sensors on the slip table.