2. Setting Up Your Projector
103
2.11.4 Setting Up the Projector
By registering the mounted option board to the slot, you can use option board by setting up the
projector. This procedure is described for the example, when signal input board is mounted to
slot B. For the operation of the projector, refer to projector’s “Users Manual”.
Tips
DCC for S2 can be used to set up.
For the procedure by using DCC for S2, refer to “Digital Cinema Communicator for S2
Installation Manual”.
[1] Set the projector in standby
mode.
[2] Enable the service
personnel menu.
These settings are for our service
personnel and cannot normally (user
mode) be used. You need to enter a
passcode to enable the service personnel
menu. Refer to the “4.1.1 When You Use
the S
ervice Personnel Menu” (page 131)
for the proc
edure.
[3] Press the MENU button on
the control panel.
"Title Select" is displayed in the menu.
From this procedure on, control panel of
the projector will be used.
[4] Press the LEFT/RIGHT
button to display
"Configuration" and press
the DOWN button.
[5] Press the LEFT/RIGHT
button to display
"Installation" and press the
DOWN button.
[6] Press the LEFT/RIGHT
button to display "Option
Slot" and press the DOWN
button.
To Next Page
Loading...
Need help?
General
