NEC NC3200S - Connecting the AC Power Supply Cable to the Projector

2. Setting Up Your Projector
62
2.3.5 Connecting the AC Power Supply Cable to the Projector
[1] Connect the AC power supply cable.
Connect the AC power supply cable (for the power supply for the projector) to the projector
through the cabling hole on the bottom of the projector.
When connected, fasten the AC power supply cable with a clamp.
[2] Mount the ferrite clamp core near the female connector of the
dedicated interface cable.
Mount the ferrite clamp care to female connector as near as possible. Also, wind the cable to ferrite
clamp core once as shown below, when mounting the cable to the ferrite clamp core.
Clamp
Clamp
AC powe
r
supply cable
Dedicated
interface cable