4. LCD Menu
144
4.3.5 Memory
This menu is the service personnel menu. For the using service personnel menu, refer to “4.1.1.
When You Use the Service Personnel Menu” (Page 131).
Sa
ve the current status of lamp and lens to the memory in the projector (lens memory function
and lamp memory function). The saved contents are assigned to the titles for use.
Memory is registered using DCC for S2. Refer to the “Digital Cinema Communicator for S2
Installation Manual” for details.
← Select the saving item
← Display the registered memory name
Press the ENTER button to display the confirmation message asking you whether this
memory can be overwritten or not.
Lamp To save the current lamp status
Lens To save the current lens status
4.4 Title Setup
This menu is the service personnel menu. For the using service personnel menu, refer to “4.1.1.
When You Use the Service Personnel Menu” (Page 131).
4.4.1 Preset Button
Use this button to set the titles to be assigned to the preset buttons (<1> to <8> buttons).
You cannot assign the same title to several preset buttons. If you want to assign any title to
another number, cancel the assignment once and then set it to any button again.
← Select the preset button number (1 to 8)
← Display the selected number of the title
←Select the titles to be assigned to the preset buttons
Select the titles from those registered in advance.
To clear assignment to preset buttons, select “---”.
To Next Page
Loading...
Need help?
General
