NEC NC3200S - Error Code List

5. Steps to upgrade to 4K
173
6.2 Error Code List
Please inquire your dealer/distributor about action to be taken for each error code.
Error code Error message Description
1 Lamp Door Open Lamp door (cover) is open.
2 Lamp OverTemp Temperature (lamp temperature) is
abnormal.
4 GPSU(12V) Fail Power supply is abnormal.
5 Lamp Unlit Lamp doesn’t light up.
6 House OverTime Lamp house cumulative time is over.
8 LPSU OverTemp Temperature (lamp power inside
temperature) is abnormal.
12 E2PROM R Fail E2PROM data read error is detected.
13 Interlock Fail Interlock is activated.
15 E2PROM W Fail E2PROM data write error is detected.
17 Pump Stop Stopped for pump error.
120 DLP Ack Fail ICP failed operation. It could be caused by
configuration files lost, disk space issue, or
DISKCHIP corruption issue.
123 Bulb OverTime Lamp bulb cumulative time is over.
125 LPSU Fail Lamp power supply is abnormal.
128 OutRange Adjusting lamp output value has set out of
range.
129 Down Lamp Power Down lamp power to decrease set inside
temperature.
130 MMS Comm Fail MMS communication error is detected.
131 MMS Fan Stop MMS fan has stopped.
132 MMS Fail MMS internal error.
133 MM Reset Executed to reset MMS.
140 DLP CommR Fail No communication with the ICP board.
(Communication I/F is RS-232C)
141 DLP CommE Fail No communication with the ICP board and
DCC.
(Communication I/F is Ethernet)
145 SensorFail Outside Air Sensor (Outside Air) read error.
146 SensorFail LPSU Intake Sensor (LPSU Intake) read error.
147 SensorFail Exhaust Sensor (Exhaust) read error.
148 SensorFail DMD-B Sensor (DMD-B) read error.
150 Fan0 Stop Fan0 has stopped.
151 Fan1 Stop Fan1 has stopped.
152 Fan2 Stop Fan2 has stopped.
153 Fan3 Stop Fan3 has stopped.
154 Fan4 Stop Fan4 has stopped.
155 Fan5 Stop Fan5 has stopped.
156 Fan6 Stop Fan6 has stopped.
157 Fan7 Stop Fan7 has stopped. (NC3200 Series)
158 Fan8 Stop Fan8 has stopped. (NC3200 Series)
159 Fan9 Stop Fan9 has stopped. (NC3200 Series)
160 GPSU Fan Stop Fan has stopped.
162 Lamp Fan0 Stop Lamp Fan0 has stopped.