NEC NC3200S - Replacement of CN6

5. Steps to upgrade to 4K
163
5.5.6 Replacement of CN6
Note
 If the PKG-NO label on the surface of the PJDIV PWB board is “V37********” (where the * are
any numbers or letters), then CN6 does not need to be replaced. You should connect to the
G-FSB COOLING ASSY FAN connector by using the current CN6. Refer to step 6 in this section
for details.
Below is the image of new CN6
Post at PJDIV PWB
Post (2P) at Router power
Post (3P) at Front underneath FAN
Post (2P) at Turret for Wide converter lens
Post (3P) at Front upper FAN
Connects to the new G-FSB COOLING ASSY FAN