EasyManua.ls Logo

NEC NC3200S - Page 174

NEC NC3200S
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5. Steps to upgrade to 4K
174
Error code Error message Description
163 Lamp Fan1 Stop Lamp Fan1 has stopped.
164 ICP Fan Stop ICP Fan has stopped.
165 GPI MACRO(n) Selection Invalid Selection of preset button (n) through GPI
is invalid because metadata is enabled.
166 GPI Control Invalid Projector control through GPI is invalid
because projector is busy.
170 OverTemp.Outside Air Set outside temperature (Outside Air) is
abnormal.
171 OverTemp Precaution Set inside temperature (LPSU Intake) is
close to over temperature.
172 OverTemp.Exhaust Set inside temperature (Exhaust) is
abnormal.
173 OverTemp.DMD-B Set inside temperature (DMD-B) is
abnormal.
174 Bulb Entry No selection of current bulb.
177 Tamper Fail Service door tamper switch of projector is
open.
178 Marriage Tamper Fail Service door tamper switch of projector is
open.
180 CPU Fail(Mem) System Test Failed. (Memory)
187 GPSU(24V) Fail Power supply is abnormal.(24V)
201 Error Log Write Fail Failed to store logs into projector system.
210 Unknown LPSU Model Unexpected LPSU is attached.
211 LPSU Fan Stop LPSU Fan has stopped.
213 12V Outside range 12V supply is out of range.
214 24V Outside range 24V supply is out of range.
215 Lamp Filter Time Over The time to exchange lamp filter.
(Future use)
216 Body Filter Time Over The time to exchange body filter.
(Future use)
220 AC On Fan Exchange Time The time to exchange Fan (AC On).
221 Power On Fan Exchange Time The time to exchange Fan (Power On).
222 Lamp Fan Exchange Time The time to exchange Lamp Fan
230 Router Fail Failed to control router.
231 SensorFail Opt Failed to control light sensor.
232 MAC Write Fail Failed to setup MAC address of CPU board.
233 Illegal MAC Address Router WAN MAC address is illegal.
235 Router Self Check Fail Router health-check error.
240 SIB Comm Fail Failed to communicate with SIB.
241 SIB Error SIB internal error.
242 SIB FPGA Reboot Executed to re-boot SIB FPGA for
recovery.
246 Fan11 Stop Fan11 has stopped. (NC3240 Series)
250 Fan0 Stop Precaution Fan0 Stop Precaution
251 Fan1 Stop Precaution Fan1 Stop Precaution
252 Fan2 Stop Precaution Fan2 Stop Precaution
253 Fan3 Stop Precaution Fan3 Stop Precaution
254 Fan4 Stop Precaution Fan4 Stop Precaution
255 Fan5 Stop Precaution Fan5 Stop Precaution
256 Fan6 Stop Precaution Fan6 Stop Precaution

Table of Contents

Related product manuals