NEC NC3200S - Page 130

4. LCD Menu
130
Main menu Submenu Description
Ref.
page
Configuration (Installation) Lens Center Moves the lens shift position to the center. 138
MMS Select Selects whether or not to use the multi media
switcher (MMS).
Baudrate Sets the PC control connector (RS-232C) data
transmission speed (bps).
Date/Time Sets the date and time on the projector.
New Bulb Resets the lamp bulb usage time and selects or
edits new entries (only when the projector is in
standby mode).
Bulb Warning Sets the lamp bulb warning time (only when the
projector is in standby mode).
New Lamp House Resets the lamp house usage time, and makes
settings or selects modes (only when the projector
is in standby mode).
Bulb Alignment Sets the lamp bulb alignment.
Usage Reset Initializes the usage time of the fan and air filter.
NewRouterSetup Sets the router with the default settings when the
router built-in the projector had been replaced.
Security Key Registers the certification file to USB memory.
Do not use usually.
Lamp Saves the current lamp setting.
(Memory)
Lens Saves the current lens setting.
144
(Title Setup) Preset Button Preset Button 1-8 Sets the titles to be assigned to the preset button
(<1> to <8> buttons).
144
Output Displays the lamp output setting.
Bulb Type [A] Displays the registered name and the
maximum/minimum current setting of the
currently used lamp bulb.
Bulb Type [W] Displays the registered name and the lamp rated
output (kW) of the currently used lamp bulb.
Lamp
Bulb Type [H] Displays the registered name and the lamp bulb
warning time (Bulb Warning Time) setting of the
currently used lamp bulb.
145
Preset Button Preset Button 1-8 Displays the titles assigned to the preset buttons
(<1> to <8> buttons).
146
Usage Displays the usage times of the projector, lamp
bulb, lamp house, bulb warning, fan, and air filter.
146
Error Code Displays the currently occurring error. 147
System Displays the version of the projector head.
(BIOS, Firmware, Data, and Serial No.)
SIB Displays the version of the signal input board.
IMB Displays the vender name and version of the
image media block.
Version
MMS (Built-in) Displays the version of the built-in multi-media
switcher (MMS). (BIOS, Firmware, Data, FPGA,
Configuration FPGA, and Serial No.)
147
IP Address System Displays the SYSTEM IP address. 149
Setup Date Displays the date when the projector was setup
(starting date of the warranty period).
149
Information
Option Status Displays the link status of the device mounted in
slot A and slot B, and the projector.
149