EasyManua.ls Logo

NEC SL100 - Page 30

NEC SL100
598 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Item No. Item Input Data Default Note
13 Loss-Of-Signal Detection Limit
If the transmit/receive voltage is
less than the setting in 10-03-13,
the system considers this as
Loss-Of-Signal and the PRI does
not come up. Note that there are
different values based on the
setting in 10-03-12 for the PRI.
0 = Level 0 (lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7 (highest sensitivity)
2
14 Service Protocol for S-point 0 = Keypad facility
1 = Specified Protocol for Aspire system
0
15 Call Busy Mode for S-point 0 = Alerting
1 = Disconnect
0
16 Two B-Channel Transfer for
PRI Service
0=off
1=on
0
17 ISDN Ringback Tone
System can provide ringback
tone, by setting 10-03-17 is set to
1 : Enable.
0=Disable
1=Enable
0
18 Type of Number
ISDN Protocol definition.
Select the number type for the
ISDN circuit.
0 = Unknown
1 = International number
2 = National number
3 = Network Specific number
4 = Subscriber number
5 = Abbreviated number
0
19 Numbering Plan Identification
ISDN Protocol definition.
Select the Numbering Plan used
for the ISDN circuit.
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
0
20 Network Exchange Selection
Select the ISDN protocol for the
ISDN circuit
0 = Standard (same as NI-2)
1 = reserved
2 = reserved
3 = DMS (A211)
4 = 5ESS
5 = DMS (A233)
6 = 4ESS
7=NI-2
0
21 Number of Ports 0 = Auto
1=4Ports
2=8Ports
3=12Ports
4=16Ports
5=20Ports
6=24Ports
7=28Ports
0
22 QSIG Operation Mode 0=Disable
1=Enable
0 (V1.5 Deleted)
For PRI (T1) PKG Setup
Physical Port Number 01 ~ 24
Item No. Item Input Data Default
01 Logical Port Number
The start port number of a T1 line is dis-
played, and 24 logic ports are automatically
assigned to a DTI (T1) line.
1 ~ 126 0
02 T1 Signal Format Selection 0 = D4 (12 Multi Frame)
1 = ESF (24 Multi Frame)
0
03 Zero Code Suppression 0 = B8ZS
1 = AMI/ZCS
0
ISSUE 1.1SL1000
Program
10
Program 10 : System Configuration Setup2-8

Table of Contents

Related product manuals