NEC SL2100 - Page 141

Program
No.
Program Name Input Data Default
13-01-01 Speed Dialing Function Setup - Speed Dialing
Auto Outgoing Call Mode
0 = Trunk Outgoing Mode (Use
trunk group assigned in PRG
13-05.)
1 = Intercom Outgoing Mode
(Follow the system routing for the
trunk access code entered.)
0
13-04-01 Speed Dialing Number and Name - Number Maximum of 36 digits (0 ~ 9,
*
,
#, @, P, R)
@ = Wait for Answer Supervision
- ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
14-01-04 Basic Trunk Data Setup - Transmit Gain Level for
Conference and Transfer Calls
1 ~ 63
(- 15.5 dB ~ + 15.5 dB in 0.5 dB
intervals)
32 (0 dB)
14-01-05 Basic Trunk Data Setup - Receive Gain Level for
Conference and Transfer Calls
1 ~ 63
(- 15.5 dB ~ + 15.5 dB in 0.5 dB
intervals)
32 (0 dB)
14-06-01 Trunk Group Routing - Trunk Group 0 = Not Set
001 ~ 050 = Trunk group No.
101 ~ 150 = 100 + Networking
System No.
1001 ~ 1050 = 1000 + Route Ta-
ble No.
Refer to the Program-
ming Manual for the
default values.
15-07-01 Programmable Function Keys - Refer to the program-
ming manual for the
default values and for
all other available op-
tions in this command.
16-02-01 Department Group Assignment for Extensions Department Groups = 1 ~ 50
Priority Order = 1 ~ 200
Refer to the Program-
ming Manual for the
default values.
20-06-01 Class of Service for Extensions - Class of Serv-
ice for Extensions
1 ~ 15 Extension 101 is Class
15 and other Extension
are Class 1
20-11-17 Class of Service Options (Hold/Transfer Service)
- Department Group Trunk-to-Trunk Transfer
(Each Telephone Group Transfer)
0 = Off
1 = On
COS 01 ~ 15 = 1
24-05-01 Department Group Transfer Target Setup - Speed
Dial Area Number
0 ~ 999 999
Trunk-to-Trunk Forwarding - DID (3) Trunk Forwarding Using DID Translation Table
Refer to Direct Inward Dialing (DID) on page 1-247 for additional DID programming.
Program
No.
Program Name Input Data Default
22-11-05 DID Translation Table - Transfer Destination
Number 1
0 = No setting
1 ~ 50 = Incoming Ring Group
101 = Not Used
102 = InMail
103 = Not Used
201 ~ 250 = Department Group
400 = VRS
401 = DISA
501 ~ 599 = DISA(VRS Mes-
sage)
1000-1999 = Common ABB Dial
(000-999)
0
ISSUE 1.0 SL2100
Features and Specifications Manual 1-127
C