NEC SL2100 - Page 245

Related Features
Call Forwarding
Department Step Calling
Transfer
InMail
Voice Response System (VRS)
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
Program
No.
Program Name Input Data Default
11-07-01 * Department Group Pilot Numbers - Extension
Group Pilot Number
Dial (Up to 8 digits) Group Number 1 ~ 49
= No Setting
Group Number 50 =
3999
16-01-01 Department Group Basic Data Setup - Depart-
ment Name
Maximum 12 characters No Setting
16-01-02 Department Group Basic Data Setup - Depart-
ment Calling Cycle
0 = Normal Routing (Priority)
1 = Easy - UCD Routing (Circu-
lar)
0
16-01-03 Department Group Basic Data Setup - Depart-
ment Routing when Busy (Auto Step Call)
0 = Normal (Intercom caller
hears busy tone.)
1 = Circular (Intercom caller
routes to an idle group member.)
0
16-01-04 Department Group Basic Data Setup - Hunting
Mode
0 = Stop at last member (non-
loop)
1 = Circular
0
16-01-05 Department Group Basic Data Setup - Extension
Group All Ring Mode Operation
0 = Manual (Ring the extensions
one at a time when the service
code are pressed.)
1 = Automatic (Ring all exten-
sions.)
0
16-01-06 Department Group Basic Data Setup - STG With-
draw Mode
0 = Disabled (Call will camp on
to the group.)
1 = Automatic (Call follows PRG
22-11-11.)
0
16-01-07 Department Group Basic Data Setup - Call Recall
Restriction for STG
0 = Disabled (Call will recall.)
1 = Enabled (Call will not recall.)
0
16-01-08 Department Group Basic Data Setup - Maximum
Queuing number for Department Group Call
0 ~ 32
0 = No Queuing
0
16-01-09 Department Group Basic Data Setup - Depart-
ment Hunting No Answer Time
0 ~ 64800 seconds 15
16-01-10 Department Group Basic Data Setup - Enhanced
Hunt Type
0 = No hunting
1 = Hunting When Busy
2 = Hunting When Not Answered
3 = Hunting When Busy or No
Answer
0
ISSUE 1.0 SL2100
Features and Specifications Manual 1-231
D