NEC SL2100 - Page 271

Program
No.
Program Name Input Data Default
22-04-01 Incoming Extension Ring Group Assignment -
Extension Number
Maximum eight Digits Group01 has 101, 102,
103, 104, 105, 106,
107, and 108 (First 8
ports ringing)
22-11-07 DID Translation Table - Call Waiting 0 = Disable (No)
1 = Enable (Yes)
0
25-04-01 VRS/DISA Transfer Ring Group W
ith No Answer/
Busy - Incoming Group Number
0 = Disconnect
01 ~ 50 = Incoming Ring Group
102 = VMI
103 = Centralized VM
104 = Assign the Speed Dial
Number
0
25-05-01 VRS/DISA Error Message Assignment - VRS
Message Number
0 ~ 100
(0 = No Setting)
0
25-06-02 VRS/DISA One-Digit Code Attendant Setup -
Destination Number
Up to eight digits
Must be a valid extension
number that is programmed
in command 11-02 or 11-04.
No Setting
25-07-01 System Timers for VRS/DISA - VRS/DISA Dial
Tone Time
0 ~ 64800 seconds 10 seconds
25-07-02 System Timers for VRS/DISA - VRS/DISA No An-
swer Time
0 ~ 64800 seconds 0
25-07-04 System Timers for VRS/DISA - Calling Time to
Automatic Answering Telephone Set
0 ~ 64800 seconds 10 seconds
25-07-05 System Timers for VRS/DISA - Duration Time for
Guidance Message by Automatic Answering Tel-
ephone Set
0 ~ 64800 seconds 10 seconds
25-07-11 System Timers for VRS/DISA - VRS/DISA Answer
Delay Time
0 ~ 64800 seconds 0 second
25-07-13 System Timers for VRS/DISA - VRS/DISA Busy
Tone Interval
0 ~ 64800 seconds 5 seconds
25-07-14 System Timers for VRS/DISA - Delayed VRS An-
swer Time
0 ~ 64800 seconds 10 seconds
25-01-01 VRS/DISA Line Basic Data Setup - VRS/DISA Dial
- In Mode
0 = Extension Number Service
Code Specify (Intercom)
1 = Use Dial Conversion Table
0
25-01-03 VRS/DISA Line Basic Data Setup - VRS/DISA
Transfer Alarm
0 = Normal (Off)
1 = Alarm (On)
0
25-02-01 DID/DISA VRS Message - Message (Talkie)
Source
Talkie Type = 1
Additional Data = 1
25-03-01 VRS/DISA Transfer Ring Group With Incorrect
Dialing - Incoming Group Number
0 = Disconnect
01 ~ 50 = Incoming Ring Group
102 = VMI
103 = Centralized VM
104 = Assign the Speed Dial
Number
1
Operation
DID calls ring extensions like normal trunk calls.
To Activate DID Call by Time Schedule:
1.
At any display Multiline Terminal, press Speaker key.
ISSUE 1.0 SL2100
Features and Specifications Manual 1-257
D