NEC SL2100 - Page 63

Program
No.
Program Name Input Data Default
84-34-01 VoIPDB DTMF Setup - DTMF Relay Mode 0 = Disable
1 = RFC 2833
2 = H.245
Refer to the Programming Man-
ual for more details.
0
84-33-01 FAX over IP Setup - Fax Relay Mode 0 = Disable
1 = Enable
2 = Each Port Mode
Refer to the Programming Man-
ual for more details.
0
84-12-33 Networking CODEC Information Basic Setup -
Number of G.722 Audio Frame
1 = 10 ms
2 = 20 ms
3 = 30 ms
4 = 40 ms
3
84-12-35 Networking CODEC Information Basic Setup - G.
722 Jitter Buffer (min)
0 ~ 300 ms 30
84-12-36 Networking CODEC Information Basic Setup - G.
722 Jitter Buffer (average)
0 ~ 300 ms 60
84-12-37 Networking CODEC Information Basic Setup - G.
722 Jitter Buffer (max)
0 ~ 300 ms 120
84-12-38 Networking CODEC Information Basic Setup -
RTP Filter
0 = Disable
1 = Enable
2 = Enable (Include SSRC)
1
84-35-01 VoIPDB RFC2833 Playout Setup - RFC2833 Play-
out Level
0 = depend on RFC2833
1 = Configuration
0
84-35-02 VoIPDB RFC2833 Playout Setup - RFC2833 Play-
out Level High
1 = -33 dBm
:
28 = -6 dBm
28
84-35-03 VoIPDB RFC2833 Playout Setup - RFC2833 Play-
out Level Low
1 = -33 dBm
:
28 = -6 dBm
28
Call Routing - Outbound
Program
No.
Program Name Input Data Default
11-09-01 Trunk Access Code - Trunk Access Code Dial (Up to four digits) 9
11-09-02 Trunk Access Code - 2nd Trunk Route Access
Code
Dial (Up to four digits) No Setting
11-12-16 Service Code Setup (for Service Access) - Trunk
Access via Networking
0~9,
*
, # Maximum of 4 digit No Setting
14-06-01 Trunk Group Routing - Trunk Group 0 = Not Set
001 ~ 050 = Trunk group No.
101 ~ 150 = 100 + Networking
System No.
1001 ~ 1050 = 1000 + Route Ta-
ble No.
Refer to Programming
Manual.
ISSUE 1.0 SL2100
Features and Specifications Manual 1-49
A