NEC SL2100 - Page 64

Program
No.
Program Name Input Data Default
15-07-01 Programmable Function Keys *06 = Trunk Access via Network-
ing
Secondary Settings:
1 = Remote System 1 from PRG
10-27
2 = Remote System 2 from PRG
10-27
:
49 = Remote System 49 from
PRG 10-27
50 = Remote System 50 from
PRG 10-27
Refer to the program-
ming manual for the
default values and for
all other available op-
tions in this command.
21-02-01 Trunk Group Routing for Extensions - Route Ta-
ble Number
0 ~ 50
0 = No Setting (Calls will not
route.)
1
21-15-01 Individual Trunk Group Routing for Extensions -
Route Table Number
0 ~ 50
0 = No Setting (Calls will not
route.)
0
21-16-01 Trunk Group Routing for Networking - Route Ta-
ble Number
0 ~ 50
0 = No Setting (Calls will not
route.)
1
25-03-01 VRS/DISA Transfer Ring Group With Incorrect
Dialing - Incoming Group Number
0 = Disconnect
01 ~ 50 = Incoming Ring Group
102 = VMI
103 = Centralized VM
104 = Assign the Speed Dial
Number
1
25-04-01 VRS/DISA Transfer Ring Group With No Answer/
Busy - Incoming Group Number
0 = Disconnect
01 ~ 50 = Incoming Ring Group
102 = VMI
103 = Centralized VM
104 = Assign the Speed Dial
Number
0
26-02-03 Dial Analysis Table for ARS/LCR -
Additional Data/Service Number
If Service Type 1 (in 26-02) : Se-
lect Trunk Group Number
0 ~ 50 (Trunk Group Number 0 =
No Route)
101 ~ 150 (Networking ID)
If Service Type 2 (in 26-02) :
F-Route Time Schedule Not
Used = 0 ~ 100
(F-Route Table Number).
Refer to Program 44-05 : ARS/F-
Route Table.
F-Route Time Schedule Used =
0 ~ 100
(F-Route Selection Number).
Refer to Program 44-04 : ARS/F-
Route Selection for Time Sched-
ule.
0
44-05-01 ARS/F-Route Table - Trunk Group Number 0 = No setting (Calls will not
route)
1 ~ 50 = Trunk Group 1 ~ 50
101 ~ 150 = Remote Systems 1
~ 50
255 = Intercom
0
SL2100 ISSUE 1.0
1-50
AspireNet
A