NEC SL2100 - Page 810

Required Component(s)
None
Related Features
PBX Compatibility/Behind PBX
Traffic Reports
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
Program
No.
Program Name Input Data Default
10-20-01 * LAN Setup for External Equipment - TCP Port Available values are: 0 ~ 65535 External Device 1 (CTI
Server) = 0
External Device 2
(ACD-MIS) = 0
External Device 5
(SMDR Output) = 0
External Device 6 (DIM
Output) = 0
External Device 8 (UC
Web Application) = 0
External Device 9 (1st
Party CTI ) = 0
External Device 11
(O&M Server) = 8010
External Device 12
(Traffic Report Output)
= 0
External Device 13
(Room Data Output for
Hotel Service) = 0
External Device 14 (IP-
DECT Directory Ac-
cess) = 0
External Device 15
(Presence) = 0
14-01-06 Basic Trunk Data Setup - SMDR Printout 0 = No (trunk will not be reported
in the SMDR print out.)
1 = Yes (trunk will be reported in
the SMDR print out.)
1
15-01-03 Basic Extension Data Setup - SMDR Printout 0 = None (Station will not be re-
ported in the SMDR print out.)
1 = Yes (Station will be reported
in the SMDR print out.)
1
15-01-14 Basic Extension Data Setup - SMDR output of
made intercom calls
0 = Disable
1 = Enable
0
15-01-15 Basic Extension Data Setup - SMDR output of
answered intercom calls
0 = Disable
1 = Enable
0
SL2100 ISSUE 1.0
1-796
Station Message Detail Recording
S