Method C - Tandem Trunking on Hang up
Program
No.
Program Name Input Data Default
14-01-04 Basic Trunk Data Setup - Transmit Gain Level for
Conference and Transfer Calls
1 ~ 57
(-15.5 dB ~ +12.5 dB in 0.5 dB
intervals)
32 (0 dB)
14-01-05 Basic Trunk Data Setup - Receive Gain Level for
Conference and Transfer Calls
1 ~ 57
(-15.5 dB ~ +12.5 dB in 0.5 dB
intervals)
32 (0 dB)
14-01-13 Basic Trunk Data Setup - Trunk-to-Trunk Trans-
fer
0 = Disable (No)
1 = Enable (Yes)
1
14-02-12 Analog Trunk Data Setup - Detect Network Dis-
connect Signal
0 = Disable (No)
1 = Enable (Yes)
0
20-06-01 Class of Service for Extensions - Class of Serv-
ice for Extensions
1 ~ 15 Extension 101 is Class
15 and other Extension
are Class 1
20-07-11 Class of Service Options (Administrator Level) -
Forced Trunk Disconnect (analog trunk only)
0 = Off
1 = On
COS1 ~ 14/COS15 = 1
20-11-11 Class of Service Options (Hold/Transfer Service)
- Automatic On-Hook Transfer
0 = Off
1 = On
COS 01 ~ 15 = 0
20-11-14 Class of Service Options (Hold/Transfer Service)
- Trunk-to-Trunk Transfer Restriction
0 = Off
1 = On
COS 01 ~ 15 = 0
20-11-21 Class of Service Options (Hold/Transfer Service)
- Restriction for Tandem Trunking on Hang Up
0 = Allow
1 = Deny
COS 01 ~ 15 = 0
24-02-07 System Options for Transfer - Trunk-to-Trunk
Transfer Release Warning Tone
0 ~ 64800 seconds 1800
24-02-10 System Options for Transfer - Disconnect Trunk-
to-Trunk
0 ~ 64800 seconds 0
25-07-07 System Timers for VRS/DISA - Long Conversa-
tion Warning Tone Time
0 ~ 64800 seconds 1800
25-07-08 System Timers for VRS/DISA - Long Conversa-
tion Disconnect Time
0 ~ 64800 seconds 30
81-01-03 CO Initial Data Setup - Clear Signal (Open Loop)
Detection Time
1 ~ 255
(5 ~ 1275 ms)
62 (310 ms)
Method D - Tandem Trunking to Speed Dial Number
Program
No.
Program Name Input Data Default
11-10-06 Service Code Setup (for System Administrator) -
Set Trunk to Trunk Transfer per Trunk
0~9,
, # Maximum of 8 digit 733
11-10-07 Service Code Setup (for System Administrator) -
Cancel Trunk to Trunk Transfer per Trunk
0~9,
, # Maximum of 8 digit 734
11-10-08 Service Code Setup (for System Administrator) -
Set Trunk to Trunk Transfer Destination per
Trunk
0~9,
, # Maximum of 8 digit 735
13-04-01 Speed Dialing Number and Name - Number Maximum of 36 digits (0 ~ 9,
,
#, @, P, R)
@ = Wait for Answer Supervision
- ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
No Setting
13-04-02 Speed Dialing Number and Name - Name Maximum 12 Characters (Use di-
al pad to enter name)
No Setting
SL2100 ISSUE 1.0
1-820
Tandem Trunking (Unsupervised Conference)
T
To Next Page
Loading...
