Trunk Disconnect Continue/Disconnect Codes
Program
No.
Program Name Input Data Default
14-01-25 Basic Trunk Data Setup - Continued/Discontin-
ued Trunk-to-Trunk Conversation
0 = Disable (No)
1 = Enable (Yes)
0
20-28-01 Trunk to Trunk Conversation - Conversation
Continue Code
0 ~ 9,
, #
(Set for one digit only)
No Setting
20-28-02 Trunk to Trunk Conversation - Conversation Dis-
connect Code
0 ~ 9,
, #
(Set for one digit only)
No Setting
20-28-03 Trunk to Trunk Conversation - Conversation
Continue Time
0 ~ 64800 seconds 0
24-02-07 System Options for Transfer - Trunk-to-Trunk
Transfer Release Warning Tone
0 ~ 64800 seconds 1800
24-02-10 System Options for Transfer - Disconnect Trunk-
to-Trunk
0 ~ 64800 seconds 0
25-07-07 System Timers for VRS/DISA - Long Conversa-
tion Warning Tone Time
0 ~ 64800 seconds 1800
25-07-08 System Timers for VRS/DISA - Long Conversa-
tion Disconnect Time
0 ~ 64800 seconds 30
80-01-02
(35)
Service Tone Setup - Basic Tone Number 0~33
0 = No Tone
33 = Default Time Slot
Refer to Programming
Manual.
Operation
Method A - Tandem Trunking from Conference
To set up a Tandem Call:
1. Place or answer first trunk call.
2. Press the Conf softkey.
3. Place or answer second trunk call.
4. To set up the tandem call, press the Conf softkey.
This sets up a Conference between you and both outside parties.
5. Press Transfer key.
- OR -
Press Hold key and dial #8 or the service code set for Unsupervised Conference/Tandem
Trunking in PRG 11-12-57.
The line keys for the trunks blink green as long as the Unsupervised Conference continues.
To end the Tandem Call:
1. Press either flashing line key.
The line keys light steadily (green). You can listen (i.e., monitor) to the call or rejoin the conversation,
based on the setting in PRG 20-13-10.
SL2100 ISSUE 1.0
1-822
Tandem Trunking (Unsupervised Conference)
T
To Next Page
Loading...
