NEC SL2100 - Page 858

Related Features
Automatic Route Selection (ARS/F-Route)
Central Office Calls, Placing
Direct Inward Dialing (DID)
Dial Tone Detection
Multiple Trunk Types
Programmable Function Keys
Prime Line Selection
Trunk Groups
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
Primary Trunk Group Routing
Program
No.
Program Name Input Data Default
11-09-01 Trunk Access Code - Trunk Access Code Dial (Up to four digits) 0
14-05-01 * Trunk Group - Trunk Group Number Trunk Port 1 ~ 128
Group Number 0 ~ 50
Priority 1 ~ 128
1
21-02-01 * Trunk Group Routing for Extensions - Route Ta-
ble Number
0 ~ 50
0 = No Setting (Calls will not
route.)
1
14-06-01 Trunk Group Routing - Trunk Group 0 = Not Set
001 ~ 050 = Trunk group No.
1001 ~ 1050 = 1000 + Route Ta-
ble No.
Refer to Programming
Manual.
Alternate Trunk Group Routing
Program
No.
Program Name Input Data Default
11-09-02 * Trunk Access Code - 2nd Trunk Route Access
Code
Dial (Up to four digits) No Setting
14-05-01 * Trunk Group - Trunk Group Setup Trunk Port 1 ~ 128
Group Number 0 ~ 50
Priority 1 ~ 128
1
21-15-01 * Individual Trunk Group Routing for Extensions -
Route Table Number
0 ~ 50
0 = No Setting (Calls will not
route.)
0
SL2100 ISSUE 1.0
1-844
Trunk Group Routing
T