NEC SL2100 - Page 917

Program
No.
Program Name Input Data Default
13-04-03 Speed Dialing Number and Name - Transfer
Mode
0 = Not Used (Calls will not be
routed based off a users caller
ID.)
1 = Internal Dial (Calls will be
routed to an internal number
specified in PRG 13-04-04.)
2 = Incoming Ring Group (Calls
will be routed to a ring group
specified in PRG 13-04-04.)
3 = Remote Monitor (Used for
the security feature and not Flex-
ible Caller ID routing.)
0
13-04-04 Speed Dialing Number and Name - Transfer Des-
tination Number
If Transfer mode is (Refer to
13-04-03) :
1 = Internal Dial Mode
1 ~ 9, 0,
*
, #, P, R, @
(Maximum 36 Characters)
2 = Incoming Ring Group
0 ~ 25 (IRG Number)
P = Pause
R = Recall
@ = Additional Digits when using
ISDN functionality
3 = Remote Monitor
Dial (Up to 8 digits)
No Setting
13-04-05 Speed Dialing Number and Name - Incoming
Ring Pattern
0 = Normal System Ring Pattern
1 ~ 4 = Tone Pattern 1 ~ 4
5 ~ 9 = Scale Pattern 1 ~ 5
10 ~ 13 = Tone Pattern 5 ~ 8
0
13-04-06 Speed Dialing Number and Name - CR/PR fea-
ture
0 = Disable
1 = Enable
0
13-04-07 Speed Dialing Number and Name - VRS Message
Number
0 ~ 100 0
15-02-55 Multiline Telephone Basic Data Setup - VRS Mes-
sage Number
0 ~ 100 0
11-10-43 Service Code Setup (for System Administrator) -
VRS Incoming
0~9,
*
, # Maximum of 8 digit 778
Operation
To Set the Incoming Voice/Melody ringing from Service Code
1. Press Service Code 778.
VRS INCOM
RI:1 STA:2
(2W Digital/IP Multiline Terminal)
2. Press Enter 1 (RI).
VRS INCOM CID
(2W Digital/IP Multiline Terminal)
ISSUE 1.0
SL2100
Features and Specifications Manual 1-903
V