Required Component(s)
None
Related Features
Abbreviated Dialing/Speed Dial
Central Office Calls, Placing
Code Restriction/Toll Restriction
Dial Tone Detection
Trunk Group Routing
Trunk Queuing/Camp On
Guide to Feature Programming
The programs listed below indicate the most commonly used programs required for this feature. The
programs are listed in the order that the installer should follow. Refer to the PCPro wizards for further
detailed programming.
• When a * is listed next to the Program Number it indicates a program that MUST be set (from a
default state) for this feature to be enabled.
ARS with trunk group routing
Program
No.
Program Name Input Data Default
11-09-01 Trunk Access Code - Trunk Access Code Dial (Up to four digits) 0
14-05-01 * Trunk Group - Trunk Group Setup Trunk Port 1 ~ 128 = Priority 1 ~
128
Trunk Group : 0 ~ 50
Refer to the Program-
ming Manual for the
default values.
26-01-01 * Automatic Route Selection (ARS/F-Route) Serv-
ice - ARS Service
0 = Disabled (ARS service is
OFF.)
1 = Enabled (ARS service is
ON.)
0
26-02-01 * Dial Analysis Table for ARS/LCR -
Dial
Maximum of 16 digits (0 ~ 9,
,
#, @)
No Setting
26-02-02 * Dial Analysis Table for ARS/LCR -
ARS Service Type
0 = No Service (Call Restricted)
1 = Route to Trunk Group
2 = Select F-Route Access
0
ISSUE 1.0 SL2100
Features and Specifications Manual 1-83
A
To Next Page
Loading...
