Program
No.
Program Name Input Data Default
26-03-01 ARS Dial Treatments - Treatment Code Maximum 36 characters No Setting
20-03-04 System Options for Single Line Telephones - Di-
al Sending Start Time for SLT or ARS
0 ~ 64800 seconds 1
ARS COS
Program
No.
Program Name Input Data Default
11-09-01 Trunk Access Code - Trunk Access Code Dial (Up to four digits) 0
14-05-01 * Trunk Group - Trunk Group Setup Trunk Port 1 ~ 128
Trunk Group No. 0 ~ 50
Priority 1 ~ 128
Refer to the Program-
ming Manual for the
default values.
26-04-01 * ARS Class of Service - Class 0 ~ 16
0 = No Class
0
26-01-01 * Automatic Route Selection (ARS/F-Route) Serv-
ice - ARS Service
0 = Disabled (ARS service is
OFF.)
1 = Enabled (ARS service is
ON.)
0
26-01-06 * Automatic Route Selection (ARS/F-Route) Serv-
ice - Class of Service Match Access
0 = Disabled (ARS service is
OFF.)
1 = Enabled (ARS service is
ON.)
0
26-01-07 Automatic Route Selection (ARS/F-Route) Serv-
ice - F-Route Access COS Reference
0 = F-Route
1 = ARS
0
26-02-01 * Dial Analysis Table for ARS/LCR -
Dial
Maximum of 16 digits (0 ~ 9,
,
#, @)
No Setting
26-02-02 * Dial Analysis Table for ARS/LCR -
ARS Service Type
0 = No Service (Call Restricted)
1 = Route to Trunk Group
2 = Select F-Route Access
0
26-02-03 * Dial Analysis Table for ARS/LCR -
Additional Data/Service Number
If Service Type 1 (in 26-02) : Se-
lect Trunk Group Number
0 ~ 50 (Trunk Group Number 0 =
No Route)
101 ~ 150
If Service Type 2 (in 26-02) :
F-Route Time Schedule Not
Used = 0 ~ 100
(F-Route Table Number).
Refer to Programming Manual..
F-Route Time Schedule Used =
0 ~ 100
(F-Route Selection Number).
Refer to Programming Manual..
0
26-02-04 * Dial Analysis Table for ARS/LCR -
ARS Class of Service
0 ~ 16
0 = No ARS Class (Call Restric-
ted)
0
26-02-05 Dial Analysis Table for ARS/LCR - 0 = No Dial Treatment Table
Added (Call will be sent out of
the system as dialed.)
1 ~ 15 = ARS Treatment tables 1
~ 15
0
26-03-01 ARS Dial Treatments - Treatment Code Maximum 36 characters No Setting
44-05-01 * ARS/F-Route Table - Trunk Group Number 0 = Trunk Group 0 (Call Restric-
ted)
1 ~ 50 = Trunk Group 1 ~ 50
0
ISSUE 1.0 SL2100
Features and Specifications Manual 1-85
A
To Next Page
Loading...
