Configure Advanced Features
124
AC1900, N900, and N450 WiFi Cable Data Gateways
8. Specify the custom service or application.
The following table describes the fields on the Ports - Custom Service screen.
Field Description
Service Name Enter a descriptive name.
Service Type From the menu, select the correct type of protocol for the service or application
(TCP, UDP, or TCP/UDP).
Note: If you are not sure which protocol to select, select TCP/UDP.
External Starting Port Enter the external starting port number for the service or application.
External Ending Port If the service or application uses a single port, enter the same port number that
you enter in the External Starting Port field.
If the service or application uses a range of ports, enter the ending port number of
the range.
Use the same port
range for Internal port
If the service or application uses the same internal ports port numbers that you
specify for the external ports, select the check box.
Internal Starting
Port
If the service or application does not use the same internal ports port numbers that
you specify for the external ports, enter the internal starting port number for the
service or application.
Internal Ending Port This field is automatically completed when you enter a port number in the Internal
Starting Port field.
To Next Page
Loading...
Need help?
General