Install and Access the Modem Router and Its Network
27
N600 and AC750 WiFi DSL Modem Routers
6. Connect the power adapter to the modem router and plug it into an electrical outlet.
Wait for the Power LED
to light solid green, which takes about 80 seconds. (The
Power LED lights solid green for about 20 seconds and then blinks for about one minute
before it lights solid green again.)
7. Connect a computer to the modem router by one of the following methods:
• Ethernet cable. Use an Ethernet cable to connect your computer to the yellow LAN1,
LAN2, or LAN3 Ethernet port on the modem router.
The product package contains a yellow Ethernet cable.
Your computer connects to the
modem router’s LAN.
• WiFi. Connect to the default WiFi network of the modem router:
a. On your computer or WiFi device, find and select the WiFi network.
The WiFi network name (SSID) is on the
product label.
b. Join the WiFi network and enter the WiFi password.
The password (network key) is on the product label.
Y
our computer or WiFi device connects to the modem router’
s WiFi network.
8. Launch a web browser.
The NETGEAR genie Setup Wizard displays.
If the NETGEAR genie Setup Wizard displays, skip to Step 10. If it does not display, do
the following:
a. In the address field of the web browser, enter www.routerlogin.net.
b. When prompted, enter admin for the user name and password for the password.
If the Setup Wizard displays, skip to Step 10. If the NETGEAR genie Setup Wizard still
does not display, see Step 9.
To Next Page
Loading...
Need help?
General
