Manage the Internet Settings Manually
42
N600 and AC750 WiFi DSL Modem Routers
Take one of the following actions:
• If your setup includes a DSL modem, power-cycle the DSL modem:
a. Unplug your DSL modem’s power, leaving the DSL modem connected to the wall
jack for your Internet service.
b. If your DSL modem includes a battery backup, remove the battery.
c. Wait 10 seconds.
d. If your DSL modem includes a battery backup, reinsert the battery.
e. Plug in your DSL modem’s power
and turn on your DSL modem.
f. Wait two minutes.
g. Select the I just power cycled the modem and waited for 2 minutes radio
button.
h. Click the
Next button.
• If your setup includes a cable or fiber modem, see if the yellow Ethernet cable is not
fully inserted or is inserted at the wrong place. If necessary, do the following:
a. Fully insert the Ethernet cable in the correct port on the cable or fiber modem
and in the red Internet port on the modem router.
b. Select the I corrected a problem with the Ethernet cable radio button.
c. Click the Next button.
• If you do not need to power-cycle the DSL modem or the Ethernet cable is already
fully inserted in the correct ports, do the following:
a. Select the None of the above radio button.
b. Click the Next button.
10. (Only if the following screen displays) Specify how to manage problems with the detection of
the IP address for the Internet connection.
The screen that might display states that a problem occurred while detecting the Internet
connection IP address.
To Next Page
Loading...
Need help?
General
