NETGEAR Nighthawk RS700 User Manual

6.
Select the Enable VLAN Tag radio button.
The page expands.
The table includes a default VLAN enabled for normal Internet access. The VLAN's
ID is 10 and has all Ethernet LAN ports and WiFi networks as members.
7.
Click the Add button.
The Add VLAN Rule page displays.
8.
Specify the following settings for the VLAN tag group:
•
Name: Enter a name for the VLAN tag group.
The name can be up to 10 characters.
•
VLAN ID: Enter a value from 1 to 4094.
•
Priority: Enter a value from 0 (lowest priority) to 7 (highest priority).
9.
Select the check box for a wired Ethernet LAN port or wireless network.
If your device is connected to an Ethernet LAN port on the router, select the wired
Ethernet LAN port check box that corresponds to the Ethernet LAN port on the router
to which the device is connected. If your device is connected to your router’s WiFi
network, select the WiFi check box that corresponds to the router’s WiFi network to
which the device is connected.
You must select at least one Ethernet LAN port or WiFi network. You can select more
than one port or WiFi network. Depending on your configuration, other devices
connected to the specified ports or WiFi networks might not be able to access the
public Internet.
10.
Click the Add button.
Your settings are saved.
The VLAN tag group is added and automatically enabled. The VLAN / Bridge Settings
page displays again.
User Manual111Manage the WAN and LAN
Network Settings
Nighthawk WiFi 7 Tri-Band Router Model RS700

NETGEAR Nighthawk RS700 Specifications

General

WiFi Speed	Up to 19 Gbps
USB Ports	1 x USB 3.0
Memory	1GB RAM
WiFi Technology	WiFi 7
Security	WPA3, VPN support
WiFi Bands	Tri-Band
Storage	512MB