NETGEAR Nighthawk RS700 User Manual

2.
Enter http://www.routerlogin.net.
A login window displays.
3.
Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED > Advanced Setup > Router / AP Mode.
The Router / AP Mode page displays.
5.
Select the AP Mode radio button.
The page adjusts.
6.
Select an IP address setting:
• Get dynamically from existing router: The other router on the network assigns
an IP address to this router while it is in AP mode.
• Use fixed IP address (not recommended): Use this setting if you want to manually
assign a specific IP address to this router while it is in AP mode. Using this option
effectively requires advanced network experience.
7.
Click the Apply button.
The IP address of the router changes, and you are disconnected.
8.
To reconnect, close and restart your browser and type http://www.routerlogin.net.
Return the router to router mode
By default, your router is set to router mode. If you changed the mode to access point
mode (AP mode), you can change the mode back to router mode.
To return the router to router mode:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter http://www.routerlogin.net.
A login window displays.
User Manual148Manage and Monitor Your
Router
Nighthawk WiFi 7 Tri-Band Router Model RS700

NETGEAR Nighthawk RS700 Specifications

General

WiFi Speed	Up to 19 Gbps
USB Ports	1 x USB 3.0
Memory	1GB RAM
WiFi Technology	WiFi 7
Security	WPA3, VPN support
WiFi Bands	Tri-Band
Storage	512MB