The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED.
The ADVANCED Home page displays.
5.
Click the Reboot button.
A confirmation pop-up window displays.
6.
Click the OK button.
The router reboots.
Troubleshoot with the LEDs
By default, the router uses standard LED settings.
Standard LED behavior when the router is powered on
After you turn on power to the router, verify that the following sequence of events occurs:
1.
When power is first applied, verify that the Power LED is lit.
2.
After about two minutes, verify the following:
•
The Internet LED is lit.
•
The WiFi LED is lit (unless you turned off the WiFi radios).
You can use the LEDs on the front panel of the router for troubleshooting.
Power LED is off
This could occur for a number of reasons. Check the following:
•
Make sure that the power adapter is securely connected to your router and securely
connected to a working power outlet.
•
Make sure that you are using the power adapter that NETGEAR supplied for this
product.
User Manual203Troubleshooting
Nighthawk WiFi 7 Tri-Band Router Model RS700
To Next Page
Loading...
Need help?
General
