NETGEAR Nighthawk RS700 User Manual

A login window displays.
4.
Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
5.
Select ADVANCED > Advanced Setup > Ethernet Settings.
The Ethernet Settings page displays.
6.
In the LAN Port Aggregation section, select a LAN port aggregation mode (by default,
LAN port aggregation is disabled):
•
Enable (LACP-IEEE 802.3ad): After you connect the Ethernet cables (see the
following step), the router communicates with the LAN device that is connected
to LAN ports 1 and 2 on your router, and checks to see if LAN port aggregation
is supported on the LAN device. If LAN port aggregation is supported, the router
automatically trunks LAN ports 1 and 2. If not, LAN ports 1 and 2 work as
independent LAN ports. We recommend that you select this mode unless your
LAN device can support a static LAG only.
•
Static: If your device supports a static LAG only, select this mode. Otherwise, we
recommend that you select the Enable (LACP-IEEE 802.3ad) radio button
instead.
7.
Click the Apply button.
Your settings are saved.
After you complete the next step, the Ethernet Port Aggregation Status field displays
if Ethernet port aggregation is active or inactive.
8.
Physically connect your LAN device to LAN ports 1 and 2 on the router.
View or change the router LAN port aggregation mode
To view or change your router’s LAN port aggregation mode:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter http://www.routerlogin.net.
A login window displays.
User Manual114Manage the WAN and LAN
Network Settings
Nighthawk WiFi 7 Tri-Band Router Model RS700

NETGEAR Nighthawk RS700 Specifications

General

WiFi Speed	Up to 19 Gbps
USB Ports	1 x USB 3.0
Memory	1GB RAM
WiFi Technology	WiFi 7
Security	WPA3, VPN support
WiFi Bands	Tri-Band
Storage	512MB