NETGEAR Nighthawk RS700 User Manual

Set an IPv6 Internet connection
The router supports many different types of IPv6 Internet connections for which you can
specify the settings manually.
Types of IPv6 Internet connections
The router can support an IPv6 Internet connection through the following connection
types:
•
Auto Detect: See Use auto detect for an IPv6 Internet connection on page 44.
•
6to4 tunnel: See Set a 6to4 tunnel IPv6 Internet connection on page 46.
•
Pass-through: See Set a pass-through IPv6 Internet connection on page 47.
•
Fixed: See Set a fixed IPv6 Internet connection on page 48.
•
DHCP: See Set a DHCP IPv6 Internet connection on page 49.
•
PPPoE: See Set a PPPoE IPv6 Internet connection on page 51.
•
Auto Config: See Use auto config for an IPv6 Internet connection on page 53.
•
6rd: See Set a 6rd IPv6 Internet connection on page 55.
Which connection type you must use depends on your IPv6 ISP. Follow the directions
that your IPv6 ISP gave you.
•
If you are not sure what type of IPv6 connection the router uses, use the Auto Detect
connection type, which lets the router detect the IPv6 type that is in use (see Use
auto detect for an IPv6 Internet connection on page 44).
•
If your ISP did not provide details, use the 6to4 tunnel connection type (see Set a
6to4 tunnel IPv6 Internet connection on page 46).
When you enable IPv6 and select any connection type other than IPv6 pass-through,
the router starts the stateful packet inspection (SPI) firewall function on the WAN interface.
The router creates connection records and checks every inbound IPv6 packet. If the
router does not expect to receive such a packet, or the packet is not in the connection
record, the router blocks this packet.
User Manual43Specify Your Internet Settings
Nighthawk WiFi 7 Tri-Band Router Model RS700

NETGEAR Nighthawk RS700 Specifications

General

WiFi Speed	Up to 19 Gbps
USB Ports	1 x USB 3.0
Memory	1GB RAM
WiFi Technology	WiFi 7
Security	WPA3, VPN support
WiFi Bands	Tri-Band
Storage	512MB