NETGEAR Nighthawk RS700 User Manual

•
A modem that support both an Internet speed that’s over 1 Gbps and two Ethernet
ports that support static Link Aggregation Control Protocol (LACP), for example, the
NETGEAR Nighthawk Multi-Gig Cable Modem, model CM1200.
To set up Internet port aggregation:
1.
Set up Internet port aggregation on your modem.
For information about how to set up Internet port aggregation on your modem, see
the documentation that came with your modem.
2.
Launch a web browser from a computer or mobile device that is connected to the
router network.
3.
Enter http://www.routerlogin.net.
A login window displays.
4.
Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
5.
Select Internet.
The Internet Setup page displays.
6.
In the WAN Preference section, select the Multi-Gig Internet (1 Gbps + 1 Gbps)
radio button.
7.
Click the Apply button.
Your settings are saved.
8.
Connect the yellow Internet port and the Ethernet LAN port 4 on your router to two
Ethernet ports on your modem.
User Manual42Specify Your Internet Settings
Nighthawk WiFi 7 Tri-Band Router Model RS700

NETGEAR Nighthawk RS700 Specifications

General

WiFi Speed	Up to 19 Gbps
USB Ports	1 x USB 3.0
Memory	1GB RAM
WiFi Technology	WiFi 7
Security	WPA3, VPN support
WiFi Bands	Tri-Band
Storage	512MB