NETGEAR Nighthawk RS700 User Manual

Quick tips
This section describes tips for troubleshooting some common problems.
Sequence to restart your network
If you must restart your network, follow this sequence:
1.
Turn off and unplug the modem.
2.
Disconnect all devices from the modem.
3.
Turn off the router.
4.
Plug in the modem and turn it on.
5.
Wait two minutes.
6.
Reconnect the router to the modem.
Do not connect any other devices to the modem.
7.
Turn on the router.
8.
Wait two minutes.
When your network is back up, you can reconnect other devices to the modem.
Check the power adapter and Ethernet cable connections
If the router does not start, make sure that the power adapter cable is securely plugged
in.
If the Internet connection or LAN connections do not function, make sure that the
Ethernet cables are securely plugged in.
The Internet LED on the router is lit if the Ethernet cable connecting the router and the
modem is plugged in securely and the modem and router are turned on.
If one or more powered-on computers are connected to the router by an Ethernet cable,
the Ethernet LAN LED lights.
User Manual201Troubleshooting
Nighthawk WiFi 7 Tri-Band Router Model RS700

NETGEAR Nighthawk RS700 Specifications

General

WiFi Speed	Up to 19 Gbps
USB Ports	1 x USB 3.0
Memory	1GB RAM
WiFi Technology	WiFi 7
Security	WPA3, VPN support
WiFi Bands	Tri-Band
Storage	512MB