over IP (VoIP) and video traffic might not work well when the SIP ALG is enabled. For
this reason, the router provides the option to disable the SIP ALG.
To disable the SIP ALG:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter http://www.routerlogin.net.
A login window displays.
3.
Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED > Setup > WAN Setup.
The WAN Setup page displays.
5.
Select the Disable SIP ALG check box.
Selecting the Disable SIP ALG check box disables the SIP ALG and clearing the
Disable SIP ALG check box enables the SIP ALG. By default, the SIP ALG is enabled.
6.
Click the Apply button.
Your settings are saved.
Change the LAN IP address settings or RIP
settings
The router is preconfigured to use private IP addresses on the local area network (LAN)
side and to act as a Dynamic Host Configuration Protocol (DHCP) server. We also refer
to the LAN IP address settings as the LAN TCP/IP settings.
The router’s default LAN IP configuration is as follows:
•
LAN IP address: 192.168.1.1
•
Subnet mask: 255.255.255.0
User Manual98Manage the WAN and LAN
Network Settings
Nighthawk WiFi 7 Tri-Band Router Model RS700
To Next Page
Loading...
Need help?
General
