NETGEAR Nighthawk RS700 User Manual

3.
Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED > Advanced Setup > Router / AP Mode.
The Router / AP Mode page displays.
5.
Select the Router Mode radio button.
The page adjusts.
6.
Click the Apply button.
The IP address of the router changes, and you are disconnected.
7.
To reconnect, close and restart your browser and type http://www.routerlogin.net.
Manage LED blinking or turn off LEDs
You can disable or enable LED blinking. You can also turn off the LEDs.
NOTE: These instructions are for disabling or enabling LEDs from the router
web interface. You can also press the LED On/Off button on the front of the
router.
To manage LED blinking or turn off the LEDs:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter http://www.routerlogin.net.
A login window displays.
3.
Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED > Advanced Setup > LED Control Settings.
User Manual149Manage and Monitor Your
Router
Nighthawk WiFi 7 Tri-Band Router Model RS700

NETGEAR Nighthawk RS700 Specifications

General

WiFi Speed	Up to 19 Gbps
USB Ports	1 x USB 3.0
Memory	1GB RAM
WiFi Technology	WiFi 7
Security	WPA3, VPN support
WiFi Bands	Tri-Band
Storage	512MB