Cable your router
Connect your router to a modem and power on your router.
Internet
10G
Ethernet
ResetPower
Figure 5. Cable your router
To cable your router:
1.
Unplug your modem, remove and reinsert the backup battery if it uses one, and
then plug the modem back in.
2.
Use the Ethernet cable to connect the modem to the yellow Internet port on the
router.
NOTE: If your Internet connection does not require a modem, connect the
Ethernet cable going to your home to the yellow Internet port on the router.
3.
Connect the power adapter to your router and plug the power adapter into an outlet.
The router’s Power LED lights solid white when the router is ready.
User Manual23Hardware Setup
Nighthawk WiFi 7 Tri-Band Router Model RS700
To Next Page
Loading...
Need help?
General
