35
Presets
Dual-row workflow
Up to two Splitter/Mixer paths can be created in a single Preset.
Take a look at the following example:
This could be a Preset for Vocals (Rows 1-2) and a Guitar+Cab
Bypass (Rows 3-4).
1/2
Out
1
In
1
Send
2
In
2
Send
Vocal chain:
Guitar chain:
• The vocal signal splits immediately after the compressor to
Row 2. This Splitter is using the Balance type, so the signal is
distributed to both rows equally.
• The Mixer joins Row 1 before the EQ. This Mixer receives input
signal from both rows in order to use the Outputs 1/2.
• The Splitter is placed immediately after the amplier. This
Splitter is using the A/B type, so the signal is sent to both rows
with custom levels.
• Row 3 sends the signal straight to the Send 1 output, including
the cab and time effects.
• Row 4 receives signal from Input 1 after the amplier. A noise
gate and EQ are added, and the signal is sent to the Send 2
output to be processed withiout the cab or time effects.
To Next Page
Loading...