newcook 3D - Cleaning Your Programmable Pot (English); Cleaning the Pot and Accessories (English); Safety Systems (English)

73
CLEANING YOUR PROGRAMMABLE POT
Your programmable pot has one of the most non-sck surfaces, made of PTFE that generates incredible non-sck
properes, this makes cleaning easier to the extent that the use of any type of pad or abrasive cleaning is not necessary to
clean the cup, even dish washable.
Along with the cup, the items that are in direct contact with the food should also be cleaned. These are the inner lid, the
lid, the silicone ring and the exhaust valve. They should be cleaned with soap and water and using a sponge or, if necessary,
a scouring pad.
To remove the inner lid and the silicone ring, pull the small holder in the inner lid and remove easily the silicone ring in it,
the important thing is to clean each me you use it, otherwise you can alter the taste or odor in the following meals to be
cooked with your programmable pot.
PUT
REMOVE
Inner lid
Silicon ring
Inner lid holder
Remove the
inner lid
Regarding the safety lter and the exhaust valve, it is important to keep them clean so they never obstruct the steam and
so that you can open your pot when you want.
The programmable cooker is a revoluonary product in terms of security systems. It has 8 interlaced systems that act
simultaneously and that make it impossible for a fault to occur:
It is important to emphasize especially the safety valve system
that prevents the opening of the programmable pot as long as
there is pressure inside, therefore, it
is fundamental to be able to open or
close the programmable cooker that
eliminates the steam that is inside,
for this it is necessary to posion the
discharge valve in the “Open” posion.
FITTING EXHAUST
VALVES
Pressure boundary system
Pressure sensor
Superheat control
Maximum temperature
control system
Safety systems intelligent
control
Valve antilock system
Steam pressure auto
exhaust
Lid open safety system
SAFETY VALVE SYSTEM
Valve body
Valve
closure