Need help?Do you have a question about the NF ZM2376 and is the answer not in the manual?
General| Brand | NF |
|---|---|
| Model | ZM2376 |
| Category | Measuring Instruments |
| Language | English |
Overview of the ZM2376 instruction manuals and chapters covered in this guide.
Essential safety guidelines and warnings for operating the ZM2376 LCR meter.
Details the primary capabilities and specifications of the ZM2376 LCR Meter.
Describes typical uses and application areas for the ZM2376 LCR Meter.
Presents a functional tree outlining the ZM2376's various operational capabilities.
Explains the fundamental operating principles and block diagram of the ZM2376.
Guidance on inspecting the instrument upon receipt and verifying package contents.
Details on installing the ZM2376, including rack mounting and environmental conditions.
Instructions for proper grounding and connecting the power supply for safe operation.
A procedure to verify the basic functionality of the ZM2376 before important measurements.
Recommendations for annual calibration and performance testing to maintain accuracy.
Identifies and describes the functions of front and rear panel components of the ZM2376.
Explains the display messages upon powering on and the initial setup procedures.
Presents a hierarchical view of the ZM2376's operational menus and functions.
Provides instructions and precautions for connecting the Device Under Test (DUT).
Details fundamental operations like setting parameters, measurement conditions, and error correction.
Enables driving the DUT with constant voltage or current for stable measurements.
Utilizes the averaging function to reduce variations in measured values caused by noise.
Shows deviation and deviation percentage from a set reference value for analysis.
Configures the comparator for bin sorting of parts based on primary and secondary parameters.
Details connecting and operating the handler interface for automated testing and sorting.
Performs measurements under multiple conditions for comprehensive analysis.
Customizes the auxiliary display content to show various settings or monitor values.
Allows saving and recalling instrument settings and correction values to/from memory.
Enables contact check and low capacitance check to detect connection failures.
Applies DC bias voltage for measuring polar capacitance, PN junctions, and battery impedance.
Details the setup for applying DC bias current, typically for inductor measurements.
Locks or unlocks front panel key operations for preventing unintended changes.
Adjusts the delay time for auto adjustment operations to improve settlement accuracy.
Procedures for resetting current settings, all settings, and operation modes to factory defaults.
Performs self-diagnosis to check the analog measurement circuit's functionality.
Displays the firmware version and last adjustment date/time of the ZM2376.
Configures USB, RS-232, or GPIB interfaces for remote control of the ZM2376.
Allows switching between standard and alternative command modes for remote control.
Lists and explains common error messages, their causes, and corrective actions.
Provides a troubleshooting table for common device issues and their solutions.
Introduction to essential maintenance procedures for optimal device performance.
Guidelines for routine cleaning and upkeep of the ZM2376's exterior.
Instructions for proper storage, repacking, and transportation of the instrument.
How to check the ZM2376 firmware version and update information.
Procedure to check electrical isolation between instrument terminals and ground.
Describes tests to verify the ZM2376's performance against specifications.
Information on obtaining necessary adjustment or calibration from NF Corporation.
Lists detailed measurement parameters, display ranges, and conditions for the ZM2376.
Provides physical dimensions and external views of the ZM2376 instrument.
To Next Page
