NF ZM2376 - Initialization; Simplified Operating Method When You Use

3.5 Basic Operations
3-23 ZM2376
3.5.3 Simplified Operating Method When You Use “ZM2376” for the First Time
This section describes the simplified operating method when you use the ZM2376 for the first time.
Do not connect the handler interface and remote control interface.
Perform operation through the procedure mentioned below:
1) Unlock the key lock
2) Initialization
3) Setting of measurement conditions
4) Connect and measure the DUT.
With the factory default settings, unlocking of key lock and initialization can be omitted.
 Unlock the key lock
When the KEY LOCK lamp lights up, first press the _SHIFT_ + [KEY LOCK] keys to unlock the key
lock. In concrete terms, after pressing the _SHIFT_ key, press the _LOCAL_ | [KEY LOCK] key with
KEY LOCK written above the key.
 Initialization
Press the _SHIFT_ + [INIT] keys to display the initialize menu, and press the _1_ key to return to the
initial setting state.
When you use the ZM2376 that has already been set variously, performing the initialization makes later
operations easy. The contents saved in the setting/correction value memory are not initialized by this
operation.
KEY LOCK lamp _SHIFT_ [KEY LOCK]
[INIT]