NF ZM2376 - 4.18 Switching the Operation Mode (alternative command)

4.18 Switching the Operation Mode (alternative command)
4-62 ZM2376
4.18 Switching the Operation Mode (alternative command)
ZM2376 can change the remote control commands by switching the operation mode.
1) Operation mode 0: Standard operation mode
Use the standard command for remote control.
The factory default setting is the operation mode 0.
The operating method and functions in the operation mode 0 are described in Chapters 3, 4, 5,
and the separate manual “ZM2376 Instruction Manual (Remote Control)”.
2) Operation mode 1: Alternative command mode
Use the alternative command for remote control instead of the standard command
Use the operation mode 1 when the alternative command is easier to use for you.
The alternative command is described in the separate manual “ZM2376 Instruction Manual
(Alternative Command)”.
The panel operation is the same as the operation mode 0.
The separate manual is included in the attached CD-ROM.
 Switching of operation mode
The operation mode is switched with the system settings menu.
_SHIFT_ + [ SYSTEM ]
Press the _SHIFT_ + [SYSTEM] keys to display the system setting menu.
SYSTEM settings
0)INTERFACE 1)BEEPER >NEXT Options (first page)
Press the _-_ _2_ _3_ _0_ _0_ keys in this order to display the operation mode setting menu as
shown below. (This option is not displayed in the system menu.)
Operation mode:0 Current setting
0)Mode 0 1)Mode 1 Options
If a setting is made or the EXIT operation is performed, the measurement screen comes back.
When the operation mode is set, the initialization equivalent to “INITIALIZE ALL” in each operation
mode is executed.
When the operation mode 0 is selected, all settings are reset to the factory default. The operation
mode cannot be initialized by any method other than the selection of operation mode 0.