NF ZM2376 - Initialization

3.2 Display at Power “ON” and Initial Settings
3-6 ZM2376
3.2.3 Initialization
ZM2376 is reset to the factory default settings in the following cases:
 At the time of shipment from factory
All settings and correction values including operation modes and memory contents are set to the
initial values.
 When full initialization of settings is specified
Except operation modes, the memory contents, settings, and correction values are reset to the
factory default settings.
 “4.14 Initializing of All Settings”
 At the power ON, if backed up setting or correction value is faulty
Faulty part is initialized.
 “3.2.2 Displays and Indications at Power “ON” ”
 When operation mode is switched
The settings and correction values except operation modes are all initialized including memory
contents.
For details of the initial setting in the operation mode 1, see “Instruction Manual (Alternative
Commands)”.
To start the operation from the initial setting state, perform initialization as follows:
• After pressing the SHIFT key, press the 0 | [INIT] key to display the initialize menu, and
press the 1 key.
Initialized items, initialized contents  “Table 3-1 Setting items and initial values”