5.1 Error Message
5-2 ZM2376
5.1 Error Message
An error in the self-diagnosis at power-on or a failure in the panel operation or remote control causes
an error message to be displayed.
This section describes the content, cause, and corrective action of main error messages.
The error messages related to the remote control are described in the separate manual “ZM2376
Instruction Manual (Remote Control)”.
When the repair is required, please contact NF Corporation or one of our representatives.
When you request the repair of ZM2376, please let us know the content of an error message if it is
displayed. An error message not listed in this instruction manual may be displayed due to a
malfunction caused by strong external noise.
Before an error message, internal status at the time when an error occurred may be displayed. When
making an inquiry to NF Corporation, giving us the internal status along with the error message will
be helpful to solve the problem.
Warning Level:n Code xxxxxxxx Error Message
Internal status Usual message
A special message not listed here may be displayed, for instance, when the firmware is updated. If
other documents are supplied, also refer to such documents.
To Next Page
Loading...
